Upgrade Auto-Leveling Heatbed Position Sensor For Anet A8 RepRap 3D Printer MX

Upgrade Auto-Leveling Heatbed Position Sensor For Anet A8 RepRap 3D Printer MX 600169652753. Features: This is an auto level sensor for Tronxy P802M P802E Models. The auto leveling position sensor is waterproof, abd anti-jamming DC. Coming with mounting plate and pre soldered connector, no wiring is needed, just unplug the original z stop and plug in sensor and screw into the back of printer. These bearings are a direct replacement for the stock LM8UU bearings used by most 3D Printers. Pretty solution for auto-adjusting heatbed level, convenient for use.. Condition:: New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitions : Brand: : Unbranded/Generic , Output current: : 300 mA: UPC: : Does not apply , Main color: : black: MPN: : Does not apply , Material: : ABS: Use for: : Tronxy P802M P802E Models , Item size: : approx.8*4.8*0.5CM: Output form: : DC three-wire NPN normally open .

Upgrade Auto-Leveling Heatbed Position Sensor For Anet A8 RepRap 3D Printer MX
Upgrade Auto-Leveling Heatbed Position Sensor For Anet A8 RepRap 3D Printer MX
Upgrade Auto-Leveling Heatbed Position Sensor For Anet A8 RepRap 3D Printer MX